LightWave Systems Microwave Oven Silicon Power / Wavehead User Manual download pdf (Page 20)

INTRODUCTION AND SPECIFICATIONS

Specifications

4 OMH-6722B

CHAPTER 1



1. Add + 0.5% from 400 to 450 nm and from 990 to 1100 nm.

2. Minimum optical power required for accurate wavelength measurement:

400 nm ~ 500 nm

100uW(-10dBm)

500 nm ~ 1100 nm

10 uW (-20 dBm)

For power measurement below these levels, use MANUAL wavelength mode.

3. For input power > 100 mW:

Add +

0.05% / 100 mW to power accuracy

Add +

0.05 nm / 100 mW to wavelength accuracy

Example: 500 mW, 850 nm, accuracy = +

4.2%, +1.2 nm

4. MANUAL wavelength mode: Add +0.5% for automatic wavelength correction.

Our goal is to design and produce the best optical test equipment available

anywhere. To achieve this, we need your ideas and comments on ways we can

improve out products. We invite you to contact us at any time with your

suggestions.

Right Display (Wavelength)

Units

Range

Resolution

nm, cm

-1

, ∆λ

500.0 to 1000.0 nm, 20,000 to 10,000 cm

-1

.1 nm, .1 cm

-1

Right Display (Wavelength)

Bargraph Percent of full scale power

Brightness 5 settings

General Specifications

Operating Temperature + 15

Cto+35

Storage Temperature -40

Cto+70

Humidity (non-condensing) >

100 µW: <85% RH

100 µW: <70% RH

Overall Dimensions 68.6 mm diameter x 30.1 mm

Weight < 0.5 kg

Input Port Diameter 6 mm

Input Type Integrating sphere

Optical Stand Accommodations 8/32 tapped hole centered

Fiber Optic Adapter FC, SC, ST

Connector to Main Unit 26 pin high-density sub-D

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comments to this Manuals

No comments

LightWave Systems Microwave Oven Silicon Power / Wavehead User Manual Page 20

Comments to this Manuals

Related products and manuals for Measuring, testing & control LightWave Systems Microwave Oven Silicon Power / Wavehead