LightWave Systems Microwave Oven Silicon Power / Wavehead User Manual download pdf (Page 32)

COMMAND REFERENCE

Error Messages

16 OMH-6722B

CHAPTER 3



Error Messages

Error messages may appear on the right display. In remote operation, the current

error list can be read by issuing the

ERR? query. When this is done, a string is

returned containing the previously unread error messages (up to ten). When the

error queue is active, bit #7 of the Status Byte is also set to one.

Appendix A of the OMM-6810B Instruction Manual contains an explanation of the

error messages which may be reported by the 6810B on the display or via remote

operation.

Programming Examples

Two examples of programming the 6810B via GPIB are shown in the 6810B

Instruction Manual, Chapter 4.

Command Name # Parameters

Expected

Description

BRIght 1 Sets the brightness of the front panel

BRIght? None Returns the level of the display brightness

CAL: POWERSET 2 Sets the user calibration power

CAL: RECall None Resets the user calibration

CAL:USER None Starts the user calibration

COND? None Returns the condition status register

ENAB:COND 1 Sets the enable register for conditions

ENAB:COND? None Returns the condition enable register

ENAB:EVENT 1 Sets the enable register for events

ENAB:EVENT? None Returns the event enable register

ERRors? None Returns errors generated since last ERR?

EVEnt? None Returns the event status register

HEAD:IDN? None Returns the head identification string

HOLD? None Returns the hold status

POWer? None Returns the power measurement

POWer:AUTO 1 Sets the power autoranging mode on or off

POWer:AUTO? None Returns the status of power autoranging

POWer:MODE 2 Sets the power display units

POWer:MODE? None Returns the power display units

POWer:OFFSET 1 Sets the power offset multiplier

POWer:OFFSET? None Returns the power offset multiplier

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

LightWave Systems Microwave Oven Silicon Power / Wavehead User Manual Page 32