LightWave Systems Microwave Oven Silicon Power / Wavehead User Manual download pdf (Page 23)

OPERATION

Front Panel Controls

4_03 OMH-6722B 7

CHAPTER 2



Unused Functions

The Multimeter function that is not utilized (disabled) when

the OMH-6722B is attached are shown to the right. If a

disabled button is pushed, the 6810B will display the error

code E-715.

All other switch functions perform as described in the OMM-6810B Instruction

Manual.

Error Display

Execution errors are indicated on the right display. Errors are shown as "E-xxx"

where xxx is a three digit number representing the unique error. Errors are

displayed for three seconds or until the error causing condition is remedied,

whichever is longer. See Appendix A in the OMM-6810B Instruction Manual for a

detailed list of error messages.

Rear Panel Connections

The OMH-6722B interfaces with the rear panel of the multimeter as described in

the following paragraphs.

Input Connector

The OMH-6722B interfaces the Multimeter via the 26-pin high density “D”

connector located on the lower left side of the rear panel. Do not attach or remove

the head while power is applied to the Optical Multimeter. Please turn the power

switch off when changing optical measurement heads.

Figure 2.2 Rear Panel Input

INPUT

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

LightWave Systems Microwave Oven Silicon Power / Wavehead User Manual Page 23